Table of Contents
Advertisement
12 BRAKE SYSTEM
12.8
86
Checking the free travel of foot brake lever
Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
–
Insert the new brake linings, insert pin
5
pins
.
Info
Always change the brake linings in pairs.
To make it easier to mount the pin, push the brake linings
against the retainer spring.
Make sure the brake linings and retainer spring are seated
correctly.
F03696-10
–
Position the brake caliper.
–
Mount and tighten screws
Guideline
Screw, front
brake caliper
–
Operate the hand brake lever repeatedly until the brake linings are
in contact with the brake disc and there is a pressure point.
F03695-10
–
Add brake fluid up to level
Guideline
A
Level
(brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
2
Position cover
–
Mount and tighten screws
Info
Use water to immediately clean up any brake fluid that has
overflowed or spilled.
F03693-10
6
, and mount cotter
4
.
M8
25 Nm (18.4 lbf ft)
A
.
5 mm (0.2 in)
p. 135)
3
with membrane
.
1
.
Loctite
®
243™
Advertisement
Table of Contents
