Quickshifter; Motorcycle Traction Control - GAS GAS SM 700 2023 Owner's Manual

8 RIDING INSTRUCTIONS
8.5
8.6
34

Quickshifter +

V01270-10

Motorcycle traction control

H02885-01
Guideline
Maximum speed before gear change
Sixth gear to fifth gear
Fifth gear to fourth gear
Fourth gear to third gear
Third gear to second gear
Second gear to first gear
If the quickshifter + is activated, you can shift up and down without actu-
ating the clutch.
Because there is no need to close the throttle grip, uninterrupted gear
shifts are possible.
The quickshifter + uses the shifter shaft position to check whether or
not a shift should be initiated, and sends a corresponding signal to the
engine control.
The motorcycle traction control (cornering MTC) lowers the engine
torque in case of loss of traction in the rear wheel. Depending on the
riding mode, different amounts of slip are allowed when the traction
control is activated.
Info
When motorcycle traction control is switched off, the rear wheel
may spin during strong acceleration and on surfaces with low
grip, resulting in a risk of crashing.
After the ignition is switched on, motorcycle traction control is
enabled again.
The motorcycle traction control MTC is switched on and off on the left
combination switch using the TC button.
Info
When the motorcycle traction control is active, the TC indica-
tor lamp flashes.
When motorcycle traction control is switched off, the TC indica-
tor lamp lights up.
165 km/h (102.5 mph)
145 km/h (90.1 mph)
120 km/h (74.6 mph)
90 km/h (55.9 mph)
60 km/h (37.3 mph)