–
6
Pull oil filter
Lock ring plier (51012011000)
–
Allow the engine oil to drain completely.
–
Thoroughly clean the parts and the sealing surfaces.
H04996-10
–
Lay the motorcycle on its side and fill the oil filter housing to about
⅓ full with engine oil.
–
Fill the oil filter with engine oil and position the oil filter in the hous-
ing.
–
Oil the O-ring of the oil filter cover and mount it together with oil
7
filter cover
.
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
H04997-10
–
Stand the motorcycle upright.
–
Remove filler plug
Engine oil
Info
Too little engine oil or poor-quality engine oil will result in
premature wear of the engine.
–
Mount and tighten the filler plug together with the O-ring.
401955-12
Danger
Danger of poisoning Exhaust gases are toxic and inhaling
them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation when
running the engine.
–
Use effective exhaust extraction when starting or run-
ning the engine in an enclosed space.
–
Start the engine and check it for leaks.
Finishing work
–
Install the engine guard. (
–
Check the engine oil level. (
SERVICE WORK ON THE ENGINE 17
out of the oil filter housing.
M6
10 Nm (7.4 lbf ft)
8
with the O-ring, and fill up with engine oil.
1.0 l (1.1 qt.)
Engine oil (SAE
10W/50) (
p. 50)
p. 115)
p. 135)
117