Programming; Display - Siemens airanger DPL PLUS Instruction Manual

Programming

Operator programmable features are identified by a Point Number and Parameter
Number. The Index refers to the Transducer (vessel) Number, Relay Number, mA Output
Number, or TS-3 Number as identified by the Index Type indicators. Parameter Numbers
have a preset Parameter Value for each Index Number.
Program the AiRanger DPL Plus to obtain the desired RUN mode operation.

Display

In PROGRAM mode, the Index Type, Index Number, Parameter Number, and Parameter
Value (as well as a variety of other programming information) may be viewed.
Note that many indicators are specific to certain programming conditions and therefore,
all indicators are not displayed at any given time.
index type
transducer
relay
analog output
TS-3
index
relay in
service
Display Segment
Parameter Number
Index Type
Index
Parameter Value
Percent
Invalid Entry
Auxiliary Function
Scroll Access Tag
Program Mode
Icon
measurement point or transducer
relay
secondary index
mA output
7ML19981BD02
index
1 2 3
program
mode
the programmable feature the Parameter Value pertains to.
see chart below
the Transducer, Relay, mA Output or TS-3 # the Parameter
Value pertains to.
the current value of the Parameter Number for the Index num-
ber displayed.
indicates the Parameter Value is displayed in percent.
indicates the value entered is questionable. The unit will not
accept values out of range.
indicates Auxiliary Function access (applies to only some
Parameter Numbers).
indicates the Parameter Value may be scroll accessed.
indicates PROGRAM mode is accessed.
Index Type
AiRanger DPL Plus – INSTRUCTION MANUAL
parameter value
4
parameter
number
Description
auxiliary
units
function
invalid
scroll access
entry
tag
Page 19