Independent Ma Setpoints (P210 And P211) - Siemens airanger DPL PLUS Instruction Manual

Enter the Point Number the mA output is based on. This value depends on whether mA
function (P201) is set as transducer or mA input.
As preset, mA outputs 1 and 2 are allocated to point numbers 1 and 2 respectively. When
Point 3 (operation) is set for difference or average (P001=4 or 5), mA output 1 and/or 2 may
be allocated to Point 3.
If Point 1 and 2 are allocated to a single mA output, the output value represents the Dual
Point average. (Parameters P001 to P007 values should be identical for both points. Point
3 Operation (P001) does not have to be set to average if Point 3 readings are not desired.
When both mA outputs are allocated to the same Point Number, the mA Setpoint
parameters may be used to establish two separate or overlapping mA output spans.
However, the mA Value / Transducer (P203) corresponds to mA Output 1 only.
P203 mA Output Value / Transducer
Displays current mA output value for the Point Number.
Primary Index
Values
This displays as an Auxiliary Reading when
does not include adjustments made using Trim features (P214 / P215).
Note:
This parameter is applicable only if any mA output has the transducer
Point Number as its input source (see P201 and P202).

Independent mA Setpoints (P210 and P211)

Use these features to reference the minimum and/or maximum mA output to any point in
the measurement range.
P201—mA
Function Settings
Level, Space, or Distance
Volume
Volume Rate
mA input or
Communications Input
Page 50
Level
Range: 0.000 to 22.00 (view only)
Enter the material level in Units (P005) or percent of Span
(P007) as referenced to Empty (P006).
Enter the volume in Max Volume (P051) units or as a per-
cent of Max Volume.
Enter the volume rate in volume/min. Ensure the % symbol
is displayed before attempting to enter a % value.
Not Applicable
AiRanger DPL Plus – INSTRUCTION MANUAL
key is pressed in the RUN mode and
Action
7ML19981BD02