Table of Contents
Advertisement
Chapter 2
Recommendations
Raven Industries recommends the following best practices when installing or operating the SmarTrax system
for the first time, at the start of the season, or when moving the SmarTrax system to another machine:
•
Install the GPS antenna in the recommended location. Refer to the following table for the machine-specific
antenna mounting location.
Note:
If your machine is not listed, install the antenna on the front-center of the cab.
Machine Preset
Case IH FLX 40x0/45x0
•
Ensure the machine's hydraulic filters have been recently changed and there are no issues with the
machine's hydraulic system (e.g., pump issues, faulty hydraulic motors, fine metal deposits in the hydraulic
hoses, etc.).
•
Ensure the machine's hydraulic system is using fresh oil and debris is flushed from the hydraulic hoses,
valves, and filters.
Raven Industries recommends the following best practices when installing the SmarTrax system:
•
Use part numbers to identify the parts.
•
Do not remove the plastic wrap from a part until it is necessary for installation.
•
Do not remove plastic caps from a part until it is necessary for installation.
Point of Reference
The instructions in this manual assume that you are standing behind the machine, looking toward the cab.
Updates
Software and manual updates are available on the Raven Applied Technology website:
4
Case IH Titan 4030 and 4530, Model Year 2013 & Newer SmarTrax™ Installation Manual
Antenna X Position
Antenna Y Position
(left to right)
(from the rear wheel
axle to the antenna
position on the cab)
Centered
http://www.ravenhelp.com
Antenna Z Position
(ground to top of
15 ft./4.57 m
11.8 ft./3.61 m
antenna)
Advertisement
Table of Contents
