Page 2
GPS, GNSS, SBAS, etc.). Therefore, Raven Industries cannot guarantee the accuracy, integrity, continuity, or availability of these services and cannot guarantee the ability to use Raven systems, or products used as components of systems, which rely upon the reception of these signals or availability of these services.
Page 3
H A P T E R NTRODUCTION Congratulations on your purchase of the Raven Smartboom system! This system is designed to provide worry-free turn on and turn off of your booms with respect to an as-applied area. The following instructions are designed to assist you in the proper installation of the Smartboom system.
Manual # 016-1001-057 H A P T E R NSTALLATION Use the following procedure to properly install the Smartboom system. Locate the 12 pin armrest harness connector behind the armrest. Disconnect and tee in the Smartboom harness. Inspect the existing 12 pin armrest connector to determine if pin 12 is populated.
Page 6
Rogator 864, 1064, 874, 1074 (Jan. 2006 & Newer) SmartBoom Installation Manual Master switch tee-in if necessary Connect the power leads to a good source of switched power. Refer to the Smartboom Operators manual for console setup instructions.
Page 11
How Can I Get Service? Bring the defective part and proof of purchase to your Raven dealer. If your dealer agrees with the warranty claim, the dealer will send the part and proof of purchase to their distributor or to Raven Industries for final approval.