Table of Contents
Advertisement
83
6. Clip Operations: Clip Operations on the Thumbnail Screen
Displaying Clip Properties
The clip properties screen for the selected clip appears when you select Thumbnail >Display Clip
Properties in the setup menu.
1
OK S Sub
2
3
1.
Current clip image
Displays the index picture and status of the
selected clip.
2.
Timecode display
TC Index: Timecode of the displayed image
Start: Timecode of the recording start point
End: Timecode of the recording end point
Duration: Duration between start and end
points
3.
Creation date and modified date
4.
Clip name
5.
Recording format
Video Codec: Video codec
Size: Picture size
FPS: Frame rate
Audio Codec: Audio codec
Ch/Bit: Audio recording channel/Number of
bits for audio recording
6.
Special recording information
7.
Recording device name
4
5
6
7
To hide the clip properties screen, do one of
the following.
Press the RESET/RETURN button: Returns to
the Thumbnail menu screen.
Press the THUMBNAIL button: Sets the
camcorder to E-E mode and displays the
camera picture.
Press the PLAY/PAUSE button: Starts playback
of the selected clip.
Adding Clip Flags to Clips
You can add clip flags (OK, NG or KP marks)
to clips to filter the display of clips based on
the clip flags. You can perform this operation
on the thumbnail screen or the filtered clip
thumbnail screen (page 83).
[Note]
This function is not available when the file system is set
to FAT.
1
Select the thumbnail for the clip to which
you want to add the clip flag, then select
Thumbnail >Set Clip Flag in the setup
menu.
2
Turn the MENU knob to select a clip flag,
then press the knob.
Setting
Added clip flag
Add OK
OK
Add NG
NG
Add KEEP
KP
The clip flag is added to the thumbnail of
the selected clip.
You can also use an assignable switch
assigned with the clip flag function to add clip
flags (page 120).
Deleting a Clip Flag
1
Select the thumbnail for the clip from
which you want to delete a clip flag, then
select Thumbnail >Set Clip Flag >Delete
Clip Flag in the setup menu.
The clip flag is deleted.
Filtering the Clips Displayed using
the Filtered Clip Screen
[Note]
This function is not available when the file system is set
to FAT.
1
Select Thumbnail >Filter Clips in the setup
menu.
2
Turn the MENU knob to select a clip flag
used to filter clips, then press the knob.
Setting
Filter clip flag
OK
OK
NG
NG
KEEP
KP
None
(Clips are not filtered)
The clip screen appears showing the clips
filtered by the selected clip flag. This
screen is referred to as the filtered clip
screen.
To cancel filtering, do one of the following.
ˎ Press the RESET/RETURN button.
ˎ
ˎ Select Thumbnail >Thumbnail View >All in
ˎ
the setup menu.
Adding/Deleting Essence Marks in
Clips
You can add (and delete) essence marks (shot
marks, recording start marks) to any frame in
a clip. You add/delete essence marks on the
essence mark thumbnail screen.
[Note]
This function is not available when the file system is set
to FAT.
Adding a shot mark
1
Select Thumbnail > Thumbnail View >
Essence Mark Thumbnail in the setup
menu.
2
Turn the MENU knob to select [All], and
then press the knob.
Advertisement
Table of Contents
