Table of Contents
Advertisement
60
5. Network Configuration: Connecting Devices using Wireless LAN
[Note]
It may take some time (30 seconds to 1 minute)
to enable station mode. Wait until the network
indicator (page 18) signal strength icon stops
flashing on the LCD monitor or in the viewfinder.
5
Select Maintenance >Network >WPS in the
setup menu.
6
Turn the MENU knob to select [Execute],
then press the knob.
7
Press the access point WPS button.
For details about WPS button operation,
refer to the instruction manual for the
access point.
When the connection is successful, the
network indicator (page 18) signal
strength icon will show a strength of 1 or
higher on the LCD monitor or in the
viewfinder.
[Note]
If the connection fails, perform the procedure again
1
from step
.
8
Connect the device to the access point.
For details about how to connect, refer to
the instruction manual for each device.
Advertisement
Table of Contents
