Sony PXW-Z750 Operating Instructions Manual page 122

122
7. Menu Display and Settings: Assigning Functions to Assignable Switches
Assignable Switch Function
setting
Electrical CC Function that switches the electrical CC filter
(3200K/4300K/5600K/6300K) applied to
white balance adjustment values.
Sequence with each press of the switch/
button:
3200K4300K5600K6300K
Can be changed using menu settings
(Electrical CC<A><B><C><D>).
[Note]
This function is not available when Maintenance
>White Filter >ND Filter C.Temp in the setup menu is
set to On.
If you set ND Filter C.Temp to On after assigning the
function, the assignable switch ceases to function.
CC5600K Applies a 5600K electrical CC filter to white
balance adjustment values.
Clip Continuous Rec Turns Clip Continuous Rec mode on/off.
Slow & Quick Motion Turns Slow & Quick Motion on/off.
Slot Select When recording media is loaded in both card
slots A and B, selects the card you want to
use.
TX Power Save Switches the wireless transmitter power
saving mode.
XAVC Proxy Rec Mode Turns the proxy data recording function on/
off.
XAVC Proxy Rec Start Starts/stops proxy recording.
Gamma Display Assist Adjusts the display on the LCD monitor and
viewfinder to the appropriate contrast for HLG
when HLG is configured or for S-Log3 when
S-Log3 is configured.
[Note]
Not available in SDR mode or during playback.
HD (Sub) P/B Mode Turns subclip playback mode on/off.
State when camcorder is Functions That Can Be Assigned to the RET Button on the Lens
next powered on
Setting retained
Assignable Switch
setting
Off
Lens RET
Rec Review
Shot Mark1
Shot Mark2
Clip Flag OK
Clip Flag NG
Setting retained Clip Flag Keep
Setting not retained Focus Magnifier
Setting retained XAVC Proxy Rec Start
–
Gamma Display Assist
Setting not retained
Setting retained
Setting not retained
Setting not retained
Setting retained
Function
No assignment
Rec Review (if playback is allowed)
Executes recording review.
Writes Shot Mark1.
Writes Shot Mark2.
Adds/Clears an OK mark to/from the clip
being recorded or played.
Adds/Clears an NG mark to/from the clip
being recorded or played.
Adds/Clears a KP (Keep) mark to/from the clip
being recorded or played.
Turns the focus magnification function on/off. Setting not retained
Starts/stops proxy recording.
Adjusts the display on the LCD monitor and
viewfinder to the appropriate contrast for HLG
when HLG is configured or for S-Log3 when
S-Log3 is configured.
[Note]
Not available in SDR mode or during playback.
State when camcorder is
next powered on
–
–
–
–
–
Setting not retained
Setting not retained
Setting not retained
Setting not retained
Setting not retained