Table of Contents
Advertisement
58
5. Network Configuration: Connecting Devices using Wireless LAN
Fixing screw
USB extension adaptor
You can adjust the position of the USB
extension adaptor over the range shown
in the following diagram.
4
Attach the protective cap (supplied) to the
USB connector of the USB extension
adaptor.
5
Open the cover of the USB wireless LAN
module connector.
Guard (supplied)
6
Plug the USB connector of the USB
extension adaptor into the USB wireless
LAN module connector.
7
Plug the CBK-WA02 into the USB
connector of the USB extension adaptor.
8
Set the wireless LAN channel in
Maintenance >Network >Channel in the
setup menu (page 113).
For details about using the CBK-WA02, refer to the
instruction manual supplied with the CBK-WA02.
[Notes]
ˎ Always turn the camcorder off before connecting or
ˎ
removing the CBK-WA02.
ˎ Attaching the CBK-WA02 and selecting Wi-Fi Station
ˎ
in Maintenance >Network >Wi-Fi Mode in the setup
menu enables connection to a 5 GHz access point.
ˎ The Ch setting "Auto(5GHz)" in Wi-Fi Access Point
ˎ
mode may not be displayed, depending on the CBK-
WA02 used.
ˎ "Auto(5GHz)" is not displayed in the menu if use of
ˎ
the CBK-WA02 in the 5 GHz band is prohibited for
outdoor use in your country or region. Check that the
use of the CBK-WA02 is permitted in your country or
region. For details, refer to the CBK-WA02 operation
manual.
If not using the CBK-WA02
Unscrew the two screws, remove the guard,
and close the connector cover.
Connecting using Wireless LAN
Access Point (Wi-Fi Access Point
Mode)
The camcorder can connect to devices that are
set up as an access point.
Computer
Smartphone/
Tablet
Install "Content Browser Mobile" on the device
to connect before starting the connection
configuration.
[Note]
The default Wi-Fi Access Point password should not
be used as-is. Use a password generated using the
following procedure.
1 Set Maintenance >Network >Setting to On.
2 Set Maintenance >Network >Wi-Fi Mode to Wi-Fi
Access Point.
3 Execute Maintenance >Network >Regenerate
Password.
One-touch connection using NFC-
equipped devices
Devices that support NFC can be connected by
one touch using NFC.
1
Select [Settings] on the device and enable
the [NFC] function.
2
Turn the camcorder on, and set
Maintenance >Network >Setting to On.
Advertisement
Table of Contents
