Getting Started; Unpacking And Inspecting; Checking The Accessories; Unpacking The Autoloader - ADIC FastStor 2 User Manual

This section describes how to install and set up your autoloader.

Unpacking and Inspecting

Before you begin, clear a desk or table so that you can unpack the autoloader.
If the room in which you are working differs from the temperature in
CAUTION:
which the autoloader was shipped or stored by 30° F (15° C) or more,
let the autoloader acclimate to the surrounding environment for at
least 12 hours before opening the shipping carton.

Checking the Accessories

The autoloader equipment box includes the following items:
• 1 US power cord
• 1 European power cord
• 1 SCSI Ultra 2 LVD Multimode Terminator
• Barcode Reader assembly

Unpacking the Autoloader

Follow the directions below to unpack the autoloader.
1 Clear a table or desk so that you have room to unpack the autoloader.
2 Inspect the shipping box for damage. If you notice any damage, report it to the shipping company
immediately.
3 Open the shipping box and remove the accessories package. Set the accessories package aside for
now.
4 Lift the autoloader and padding out of the box and place it on the work surface, top facing up.
CAUTION:
FastStor 2 User's Guide
Do not set the autoloader on its end or side.

Getting Started

5