Configuring the Barcode Reader
If you have just installed a barcode reader, use the operator panel to configure it.
1
From the main menu, press + or – until Go offline appears. Press ENTER.
1
Press + or – until Configuration appears. Press ENTER.
2
Press + or – until Barcode Reader OFF appears. Press ENTER.
3
Press + or – until BCR CHANGE TO: ON appears. Press ENTER.
The Enable BCR message appears on the operator panel. Then the barcode reader scans all slots.
After the barcode reader is enabled, the autoloader and the host system sense its presence.
Operationally, the barcode reader is controlled by the host software.
Configuring the Remote Management Unit
Before you configure the RMU, obtain a valid IP address from your system administrator and use an
Ethernet cable to connect the Ethernet port on the back of the RMU to an Ethernet port on a working
network.
In order for the RMU to function properly, the system running your web browser must be set to accept
cookies.
1
Press + or – until Go offline appears. Press ENTER.
2
Press + or – until Configuration appears. Press ENTER.
3
Press + or – until Net Parameters appears. Press ENTER.
4
Press + or – until Network OFF appears. Press ENTER.
5
Press + to change the display to Network CHANGE TO: ON. Press ENTER.
6
Press + or – until DHCP OFF appears.
•
If you are using DHCP, press ENTER. Press + or – until DHCP CHANGE TO: ON appears.
Press ENTER. Press CANCEL to move back up the menu tree.You are prompted to cycle power.
For information, refer to
•
If you are not using DHCP, continue with
7
Press + or – until IP Address appears. Press ENTER.
The cursor defaults to the first digit of the default IP address "000.000.000".
8
Configure each digit of the IP address:
•
Press ENTER to retain the "0"
•
Press + to increment the digit
•
Press – to decrement the digit.
When the IP address is correct, press ENTER. If your Ethernet network does not require a network
gateway or network mask, continue with
9
If your Ethernet network requires a network gateway, press + or – until GATEWAY ADDRESS appears.
•
Press ENTER. The cursor defaults to the first digit of the default gateway address
"000.000.000".
•
Configure each digit of the gateway address:
14
Powering on the Autoloader
step 7 on page
step 11 on page
on page 13. Exit this procedure.
4-14.
4-15.
Operating the Autoloader