Getting Started; Unpacking And Inspecting; Checking The Accessories - ADIC Scalar 24 Installation And Operation Manual

Scalar 24

Getting Started

This section describes how to install and set up the Scalar 24. The steps involved in installation
include:
•

Unpacking and Inspecting

•

Checking the Accessories

• Installing Scalar 24 Hardware
• Setting up your Scalar 24
• Preparing the Host Computer
Unpacking and Inspecting
Unpack all items from the carton. Save the packing materials in case you need to move or ship the
system in the future.
CAUTION: You must ship the Scalar 24 in the original or equivalent packing materials
or your warranty may be invalidated.
Complete either the written registration card or register the product on the ADIC website at
www.adic.com. The serial number is available through the Operator Panel or is alternately
available on the inside your Scalar 24, below the right magazine. (You will need to remove the
magazine to view the label.)
Checking the Accessories
Check to make certain that the following items are included with your Scalar 24 and that none of
them are damaged:
• US power cord
• European power cord
• One 6 ft. SCSI cable with HD/68-pin connectors
• One 1 ft. SCSI cable (dual drive version only)
• Active 68-pin SCSI bus terminator
• One data cartridge
• One cleaning cartridge
• Two keys for the front door
• Installation and Operation Guide CD-ROM
• Quick Start Guide
• Warranty Registration card
NOTE: Store the CD-ROM and keys in a safe location for preventative maintenance or service
activity.
Getting Started 4-1