Resetting The Configuration; Using The Rmu Maintenance Pages; Running Operations; Running The General Diagnostic Test - ADIC FastStor 2 User Manual

Quantum faststor 2: user guide
Hide thumbs Also See for FastStor 2:
Table of Contents

Advertisement

SMTP server address

Resetting the Configuration

The following parameters can be reset:
Label
Restore factory defaults

Using the RMU Maintenance Pages

Only administrators and service personnel have access to the RMU Maintenance page. The following
parameters can be set by means of the Maintenance page:
Operations
General diagnostic
Advanced diagnostic
Firmware
Reset

Running Operations

The Operations page allows users at the system administrator level to run the following predefined
operations:
Reinitialize library controller
Perform inventory scan
Load cartridge into drive
Unload cartridge from drive
Import to slot
Export from slot
Perform clean process
Perform drive upgrade
Bulk exchange
These same operations can be selected by using the operator panel. Depending on the operation selected,
a slot number may also be required. All available slots are either enabled or disabled according to the
inventory status of the media. Click Execute to start the selected operation. There is no stop button to stop
the selected operation. Wait for the operation to complete and then check the status.

Running the General Diagnostic Test

The General Diagnostic page allows users at the system administrator level to run the system test. To run
system tests, select the number of test cycles and click Execute. To cancel a test before its normal
completion, click Stop.
36
IP address of the SMTP server used to send mail.
Description
Press Reset to restore the factory defaults. Power cycle the
unit after the reset is completed.
Using the Remote Management Unit

Advertisement

Table of Contents
loading

Table of Contents