Running The Advanced Diagnostic Tests; Updating Firmware; Resetting The Autoloader; Accessing Log Files - ADIC FastStor 2 User Manual

Running the Advanced Diagnostic Tests

The Advanced Diagnostic page allows users at the service level to run the following predefined
operations:
• Load/Unload test
• Belt test
• Slider test
• Gripper test
• Picker test
• Door Test
To run system tests, select the number of test cycles and click Execute. To cancel a test before its normal
completion, click Stop.

Updating Firmware

Use the RMU Firmware page to support network-based firmware upgrades for the autoloader. Select the
appropriate file from a PC or network-attached server. Click Update to upload the file to the autoloader.
There is no way to back up the current firmware file, so be sure you have access to older firmware revisions.

Resetting the Autoloader

The Reset page is used to perform an autoloader reset. During an autoloader reset the connection to the
autoloader can be lost. If this happens, reload the RMU page manually.

Accessing Log Files

The RMU Logs page displays log entries for the system or for the drive. The log entries are browsable. You
can specify the number of entries per page and the entry start number. Log entries can also be stored to a
file. Trace logs can be deleted from the system. Refer to
descriptions of the possible autoloader error numbers generated in the log.
FastStor 2 User's Guide
Viewing Autoloader Error Codes on page 47 for
37