Table of Contents
Advertisement
12. Loosen the precharger thumbscrew, and transfer/separator
charger thumbscrew, and pull the chargers out of the printer.
(See page 58.)
13. Place the chargers on a flat, clean work surface.
14. Using the brush cleaner and the wire cleaner (listed in Table 2
on page 80). Removing the dust and dirt on the wires. When
dirt is caked on, the wires feel gritty. When clean, the wires feel
smooth.
15. Install the chargers. Fasten the charger screws to secure them.
Cleaning The Fuser Unit Cover Glass
CAUTION
The fuser unit remains hot after operation. Wait to handle it
until it has completely cooled down before handling it.
Die Einbrennvorrichtung behält auch nach dem Betrieb ihre
Temperatur bei. Fassen Sie sie erst an, wenn sie vollständig
abgekuhlt ist.
La unidad de fusor estará a alta temperatura después de
funcionar. Espere a que se haya en friado por completo antes
de manipularia.
L'unité de four est encore trés chaude aprés chaque
opération. Attendez qu'elle refroidisse complétement avant de
la manipuler.
Dopo l'uso, l'unitá fusore é calda. Attendere il completo
raffeddamento dell'unitá prima di intervenir sulla medesima.
1. Turn the power switch OFF.
2. Open the printer front upper cover. (See page 49.)
Cleaning The Fuser Unit Cover Glass
WARNUNG
AVISO
ATTENTION
AVVERTENZA
105
Advertisement
Table of Contents
