Printronix L5035 Operator's Manual page 107

4. Lower the transport surface by pressing down on the green
lever on the transport unit.
5
4
3
Legend:
1) Holding Plate
2) Thumbscrew
3) Green Lever
4) Fuser Unit
5) Thumbscrew (not visible in figure)
5. Loosen the thumbscrews on the right and left fuser unit holding
plates.
6. Grasp the handle and pull out the fuser unit until the second
handle is visible.
7. With the other hand, grasp the second handle and remove the
fuser from the printer.
8. Place the fuser on a clean, flat surface with the cover glass
facing up.
Cleaning The Fuser Unit Cover Glass
1
2
107