Table of Contents
Advertisement
Chapter 2
Power Paper Stacker (Option)
NOTE: Normal Mode supports up to 28 lb. bond (105 g/m
Setting The Stacker Page Length
Set the stacker page length to match the actual page length. On the
side of the stacker, locate the adjustment knob and the window
containing a measuring gauge (a pointer with a scale). Rotate the
knob until the pointer matches the page length being used. See the
illustration on page 31.
Setting The Printer Page Length
NOTE: If the printer page length does not match the stacker page
Removing Paper
1. Upon completion of a print job, press the PAGE EJECT key on
the printer control panel, and separate the paper at the
perforation.
2. Press the DOWN key on the stacker to lower the elevator
(stacking table).
3. Press the STOP key on the stacker when the elevator is about
half-way down.
42
11.0
11.5
12.0
Mode must be used for media weights greater than 34 lb.
2
bond (128 g/m
). Some media that are 28 lb. bond (105 g/
2
m
) and higher require Heavy Mode for reliable stacking.
length, the timing of the stacker swinger arm will be
incorrect, resulting in a folding error.
Set the printer page length by following the instructions for
changing printer configurations. Refer to the User's
Manual for details.
5.3
5.0
4.8
2
). Heavy
Advertisement
Table of Contents
