Table of Contents
Advertisement
Chapter 5
System Status And Error Messages
K1
File Not Compatible
K2
Wrong File Checksum
K3
DC Program Not Valid
K4
No Flash File System
K5
DRAM Fail at Address
xxxxxxxx
K6
Flash Memory Fail
K7
Program Flash Fail at
xxxxxxxx
K8
Flash Memory Full
K9
Program Needs More
DRAM
L0
Invalid DRAM */
Configuration
TABLE NOTES:
1. For any error with Reprint on Fault enabled: If the printer stops
while in the middle of printing a page, reloading the paper and
reprinting are required. There may be other cases requiring
reloading and reprinting; if so, a message will appear.
2. For any error with Reprint on Fault disabled: If the printer stops
while in the middle of printing a page, reloading the paper is
required and pages are lost.
3. For error numbers 01, 14, and 15: If the error occurs while
paper is not moving, it is not necessary to reload or reprint.
4. For error number 02: If the error is caused by a paper-empty at
the lower sensor (Paper Near End Sensor), it is not necessary
to reprint.
5. Status message only. No operator action required to clear
message.
148
á
á
á
á
á
á
á
á
á
á
Advertisement
Table of Contents
