Table of Contents
Advertisement
Chapter 3
Replacement Intervals
10. Vacuum the toner from the toner spray-guard brush on the
developing unit.
Adding New Developer
11. Shake the new developer bottle several times, remove the
bottle cap, and screw the nozzle tightly onto the bottle.
12. While rotating the developing roller knob counterclockwise,
evenly pour the entire bottle of developer powder into the
developing unit.
13. Replace the cover and tighten the screws.
IMPORTANT
If toner or developer spills on clothing, use cold water to
remove it.
Developing Unit Installation
14. Install the developing unit into the printer (see steps 1 through
18, starting on page 77.
74
1
Legend:
1)
Bottle of new Developer
2)
Developing Roller Knob
2
Advertisement
Table of Contents
