Table of Contents
Advertisement
Chapter 4
General Cleaning
14. Using the brush cleaner and the wire cleaner (listed on page
68), remove the dust and dirt on the wires. The precharger
contains one wire, while the transfer/separator charger
contains two wires. When clean, the wires feel smooth.
15. After cleaning, return the chargers to their original positions.
Fasten the charger screws to secure them.
Cleaning The Fuser Unit Cover Glass
WARNING
The fuser unit remains hot after operation. Wait until it has
completely cooled down before handling it.
Die Einbrennvorrichtung behält auch nach dem Betrieb ihre
Temperatur bei. Fassen Sie sie erst an, wenn sie vollständig
abgekuhlt ist.
La unidad de fusor estará a alta temperatura después de
funcionar. Espere a que se haya en friado por completo antes
de manipularia.
L'unité de four est encore trés chaude aprés chaque
opération. Attendez qu'elle refroidisse complétement avant de
la manipuler.
Dopo l'uso, l'unitá fusore é calda. Attendere il completo
raffeddamento dell'unitá prima di intervenir sulla medesima.
Do not scratch or place your hands directly on the cover glass.
IMPORTANT
Do not use any cleaners or chemicals on the Fuser Unit Cover
Glass. Use only the scraper.
1. Turn the power switch OFF.
2. Open the printer upper doors. (See page 42.)
90
WARNUNG
AVISO
ATTENTION
AVVERTENZA
Advertisement
Table of Contents
