Table of Contents
Advertisement
8. Place the old developing unit in a plastic bag and dispose of it
properly.
9. Vacuum any spilled toner.
10. Remove a new developing unit from its package, and add
developer to the unit. (See"Adding New Developer," starting on
page 74)
Developing Unit Installation
CAUTION
Failure to perform step 11 will damage the photoreceptor
drum.
11. On the developing unit, rotate the lever fully clockwise so that it
is pointing straight up. (See page 74.)
12. Holding the lever in one hand and the hanger in the other hand,
insert the developing unit on the guide rail.
13. Rotate the hanger to the right so that it rests against the
developing unit, and push the developing unit in. (See page
74.)
Developing Unit Installation
77
Advertisement
Table of Contents
