Table of Contents
Advertisement
9. Remove the discharge LED by pulling it toward you.
10. Using a Toraysee cloth (listed in Table 2 on page 80), wipe off
the dirt on the discharge LED.
Legend:
11. Return the discharge LED to its original position.
Photoreceptor Drum
12. Remove the developing unit from the printer. (Refer to Chapter
3, "Consumables Replacement.")
CAUTION
When cleaning the photoreceptor drum, observe the following
precaution:
•
Do not touch the drum surface with your hands.
•
To prevent the drum surface from being scratched, clean it
in a location free of dust.
•
Cleaning the drum may result in clothing stains. A drum
left unused in the printer for a long time after cleaning may
especially be affected. Therefore, after cleaning and
installing the drum in the printer, use maximum size paper
to print an image repeatedly until no stains remain. Stains
will usually be cleared after printing a few dozen pages.
13. Remove the photoreceptor drum from the printer. (Refer to
Chapter 3, "Consumables Replacement.")
14. Place the drum on a covered work surface.
1)
Discharge LED
Photoreceptor Drum
1
117
Advertisement
Table of Contents
