Power State Commands - SMART Board SBID-MX055-V3N-PW Installation And Maintenance Manual

Appendix C Managing SMART Board MX (V3, V2, and V2-C) series displays using RS-232
The display has six power states:
Power state Description
ON The display is in normal operating mode.
READY The screen is off, but the display is ready to turn on when one of the following
occurs:
STANDBY The screen is off, and the display is in a low power state. The display enters READY
or ON state when one of the following occurs:
This power state is the default energy saving mode for displays set to a non-EU
location.
Note
The EU uses "networked standby" to describe this power state.
POWERSAVE The screen is off, and the display is a very low power state. The display enters
READY or ON state when one of the following occurs:
This power state is the default energy saving mode for displays set to an EU
location.
Note
The EU uses "standby" to describe this power state.
UPDATEON The display is updating firmware. Do not turn off the display.
UPDATEREADY The display is updating firmware while the screen is off. Do not turn off the
display.
With the exception of get powerstate and set powerstate, commands are available only when the
display is in READY or ON power state.
smarttech.com/kb/171555
l A user presses the Power button
control.
You send the set powerstate=on command.
l
The display receives a video signal.
l
l A user presses the Power button
control.
You send the set powerstate=standby command.
l
l A user presses the Power button
control.
You send the set powerstate=ready or set powerstate=on command.
l
on the convenience panel or the remote
on the front control panel or the remote
on the front control panel or the remote
104