SMART Board SBID-MX055-V3N-PW Installation And Maintenance Manual page 115

Appendix D Managing SMART Board MX series displays using RS-232
Get command
get volume
get mute
get fwversion
get serialnum
get partnum
get videofreeze
Note
This command is only available in
SMART Board MX firmware 1.8.7 or
later.
smarttech.com/kb/171555
Set command
set volume[Value]
Where [Value] is one of the following:
+[Value]
l
-[Value]
l
=[0–100]
l
set mute[Value]
Where [Value] is one of the following:
=on
l
=off
l
fwversion=[Value]
Where [Value] is the firmware version.
serialnum=[Value]
Where [Value] is the display's serial
number.
Note
If multiple displays are connected, the
response includes the serial numbers
for all displays, separated by
commas.
partnum=[Value]
Where [Value] is the part number,
including the revision.
set videofreeze=[Value]
Where [Value] is one of the following:
=on
l
=off
l
Note
This command is only available in
SMART Board MX firmware 1.8.7 or
later.
Response
volume=[Value]
Where [Value] is a number between 0
and 100
mute=[Value]
Where [Value] is one of the following:
on
l
off
l
videofreeze=[Value]
Where [Value] is one of the following:
on
l
off
l
Note
This command is only available in
SMART Board MX firmware 1.8.7 or
later.
116