Commands - SMART Board SBID-MX055-V3N-PW Installation And Maintenance Manual

Appendix D Managing SMART Board MX series displays using RS-232

Commands

Get command
get powerstate
get input
get brightness
smarttech.com/kb/171555
Set command
set powerstate[Value]
Where [Value] is one of the following:
= on
l
= ready
l
Notes
If the command returns an
l
"invalid command" message,
add spaces around the
operator symbol (=).
When the screen is in a low
l
power state, it doesn't respond
to any RS-232 commands.
Disable Power saving mode to
prevent the display from
entering a low power state. See
Power saving mode on page 95.
If the display is in UPDATEON or
l
UPDATEREADY state, it might
not change power states after it
receives the command.
set input[Value]
Where [Value] is one of the following:
=OPS
l
=OPSCC
l
=HDMI1
l
=HDMI2
l
=HDMI3
l
=VGA
l
set brightness[Value]
Where [Value] is one of the following:
+[Value]
l
-[Value]
l
=[5–100]
l
Response
powerstate=[Value]
Where [Value] is one of the following:
on
l
ready
l
updateon
l
updateready
l
input=[Value]
Where [Value] is one of the following:
=OPS
l
=OPSCC
l
=HDMI1
l
=HDMI2
l
=HDMI3
l
=VGA
l
=ANDROID
l
Notes
=OPSCC is only available if you
l
install an AM50 iQ appliance
and compute card.
=ANDROID is the display's
l
settings.
brightness=[Value]
Where [Value] is a number between 5
and 100
Note
Enabling Auto Brightness overrides
any brightness values set manually.
115