SMART Board SBID-MX055-V3N-PW Installation And Maintenance Manual page 32

Chapter 2 Installing the display
To turn on and set up the display for the first time
Important
Install the OPS PC module before you turn the display on.
Notes
Touch is not available right after waking up the display or turning it on. Wait a few seconds and
l
then the display will respond to touch.
If a USB drive is connected to the display's service port, do not remove the USB drive. The USB
l
drive contains an important firmware update.
1. Flick the switch beside the AC power inlet to the ON (I) position.
SMART Board MX (V2, V2-C, and V3) series
o
55" models
SMART Board MX series
o
65" models
2. Press the Power button
3. Select your preferred language, and then tap Next.
4. Select your country, and then tap Next.
5. Select your time zone, and then tap Next.
6. Set the date, and then tap Next.
7. Set the time, and then tap Next.
8. Name the display, and then tap Next.
smarttech.com/kb/171555
65" models
75" models
on the front control panel or remote control
75" and 86" models
86" models
32