Update - SMART Board SBID-MX055-V3N-PW Installation And Maintenance Manual

Appendix B Adjusting display settings
Option
Power saving mode
Default input
Use default touch settings
Power on RS232
HDMI [connector number]-
EDID version

Update

Option
Firmware version
Update
smarttech.com/kb/171555
Values Function
Enable Enables or disables power saving
mode
Disable
OPS Select a default input when the
display is turned on.
HDMI1
HDMI2
HDMI3
VGA
Enabled Sets the number of touch points.
Disabled
Enabled When enabled, RS-232 can be used
to turn on the display from low
Disabled
power state (soft off).
Default Sets the HDMI-EDID version of the
display's active HDMI connector to
EDID 1.4
Default, EDID 1.4 or EDID 2.0.
EDID 2.0
Note
Default is selected by default.
Values Function
[N/A] Shows technical information about
the display's scalar firmware.
[N/A] Checks for updates to the system
software
Notes
Enabled by default.
When enabled, power saving mode
activates after 90 minutes of
inactivity.
Enabling Power saving mode makes
RS-232 control of the display
unavailable until the display is turned
on using the power button on the
front control panel .
OPS is enabled by default.
Default is Enabled.
Select Enabled to use 10 touch
points.
Select Disabled to use 20 touch
points.
Default is Disabled.
When Default is selected, the display
automatically detects a connected
device's HDMI-EDID version and
switches the display's HDMI
connector between EDID 1.4 and 2.0.
This feature might not work
consistently for older or non-
compliant EDID 1.4 devices.
Notes
To see the firmware version use the
About option (see About below.
If an update is available, the text
changes to Apply update now.
Note
The display must be connected to
the Internet to check for system
software updates. Check the
display's network settings.
To check the network settings, see
Network on page 92.
95