Power States - SMART Board SBID-MX055-V3N-PW Installation And Maintenance Manual

Appendix D Managing SMART Board MX series displays using RS-232

Power states

The display has the following power states:
Power state Description
ON The display is in normal operating mode.
READY The screen is off, but the display is ready to turn on when:
SOFT OFF (low The screen is in a low power state (soft off) and won't respond to RS-232
power state) commands. Disable Power saving mode to prevent the display from entering a
low power state. See Power saving mode on page 95.
The display turns on when:
UPDATEON The display is updating firmware. Do not turn off the display.
UPDATEREADY The display is updating firmware while the screen is off. Do not turn off the
display.
With the exception of get powerstate and set powerstate, commands are available only when the
display is in ON power state.
smarttech.com/kb/171555
l A user presses the Power button
A user presses the Power button on the remote control.
l
You send the set powerstate=on command.
l
Tip
If the set powerstate command returns an "invalid command" message,
add spaces around the operator symbol (=).
l A user presses the Power button
A user presses the Power button on the remote control.
l
on the front control panel.
on the front control panel.
114