Viewing A Connected Computer's Input; Setting A Connected Computer's Resolution And Refresh Rate - SMART Board SBID-6265S-C Installation And Maintenance Manual

Chapter 3
Connecting computers and other devices
NOTE
Install SMART software on computers you connect to the display (see Installing SMART software on
l
page 30).
You can charge devices connected to the USB Type-C receptacle. The display can provide up to
l
60 W to connected devices.

Viewing a connected computer's input

Use the Input app to view a connected computer's input on the display.
To view a connected computer's input
1. Connect the computer to the display.
2. Do one of the following:
If iQ is enabled
Tap Input on the Home screen.
OR
Press the Input
The display shows thumbnails of the devices that are connected to the display:
A gray thumbnail indicates no device is connected to an input.
o
A blue thumbnail indicates a device is connected to an input but is in Sleep mode.
o
A thumbnail showing a preview screen indicates an active device is connected to an input.
o
TIP
If iQ is disabled and you want a computer's input to appear whenever you wake up the display, tap
the star in the upper-left corner of the computer's thumbnail.
3. Tap the computer's thumbnail.

Setting a connected computer's resolution and refresh rate

This table presents the recommend resolutions and refresh rates for the display's inputs:
Input source
HDMI 1
HDMI 2
smarttech.com/kb/171414
on the remote control.
Resolution
3840 × 2160
3840 × 2160
If iQ is disabled
Press the Home button
on the remote control.
Refresh rate
60 Hz
60 Hz
or the Input button
32