Viewing A Connected Computer's Input - SMART Board SBID-6265S-P User Manual

CHAPTER 4
CONNECTING COMPUTERS AND OTHER DEVICES
NOTES
Install SMART software on any computers you connect to the display (see Installing and
l
using SMART software on page 27).
Your organization's installers might have connected cables to the display and run the cables
l
behind a wall or under the floor to a desk or table where you can place your computer.

Viewing a connected computer's input

Use the Input app to view a connected computer's input on the display.
To view a connected computer's input
1. Connect the computer to the display.
2. Do one of the following:
If iQ is enabled
Tap the Home button
screen, and then tap Input
OR
Press the Input button
control.
The display shows thumbnails of the devices that are connected to the display's inputs:
A gray thumbnail indicates no device is connected to an input.
o
A blue thumbnail indicates a device is connected to an input but is in Sleep mode.
o
A thumbnail showing a preview screen indicates an active device is connected to an
o
input.
TIP
If iQ is disabled and you want a computer's input to appear whenever you wake up the
display, tap the star in the upper-left corner of the computer's thumbnail.
3. Tap the computer's thumbnail.
30 smarttech.com/kb/171415
If iQ is disabled
below the Tap the Home button
screen.
.
OR
Press the Home button
on the remote
button
below the
or the Input
on the remote control.