Replacing The Pens And Erasers; Removing And Transporting The Display - SMART Board SBID-6265S-C Installation And Maintenance Manual

Chapter 4
Maintaining the display
If condensation appears under the screen after you turn on the display, select an active video source and
leave the display on for 48 hours. If the condensation doesn't dissipate, contact SMART Support if the
display is still under warranty.
If there is enough moisture between the layers to cause the moisture to drip and run, remove power
immediately and contact SMART Support if the display is still under warranty.

Replacing the pens and erasers

To prevent damage to the display's anti-glare coating, replace a pen if its nib or eraser pad become worn.
You can purchase replacement pens and erasers from the Store for SMART Parts
(see smarttech.com/support/parts-store).
NOTE
For pen and eraser part numbers, refer to the service parts diagrams.

Removing and transporting the display

On occasion, you might need to remove the display from its current wall mount and transport it to another
location.
To remove the display safely, use two or more trained installers.
WARNING
Do not attempt to move the display by yourself. The display is very heavy.
l
Do not move the display by connecting a rope or wire to the handles on the back. The display can fall
l
and cause injury and product damage.
IMPORTANT
Follow the documentation included with any third-party mounting hardware.
To remove the display
1. Turn off any connected computers.
2. Turn off the display (see Turning off, turning on, and resetting the display on page 40).
3. Flick the switch beside the AC power inlet to the OFF (O) position.
4. Remove all accessible cables and connectors.
5. Remove any modules from the accessory slot.
smarttech.com/kb/171414 44