Input Commands - SMART Board SBID-6265S-C Installation And Maintenance Manual

Appendix C
Managing the display using RS-232
Power state Description
POWERSAVE The screen is off, and the display is a very low power state. The display enters
READY or ON state when one of the following occurs:
This power state is the default energy saving mode for displays set to an EU location.
NOTE
The EU uses "standby" to describe this power state.
UPDATEON The display is updating firmware. Do not turn off the display.
UPDATEREADY The display is updating firmware while the screen is off. Do not turn off the display.
With the exception of get powerstate and set powerstate, commands are available only when the
display is in READY or ON power state.

Input commands

Get command
If one display is connected
get input
smarttech.com/kb/171414
A user presses the Power button
l
control.
You send the set powerstate=powersave command.
l
Set command
set input[Value]
Where [Value] is one of the following:
=hdmi1
l
=hdmi2
l
=hdmi3
l
=vga1
l
=ops1
l
=usbc1
l
=android
l
NOTE
The usbc1 set command applies
only to displays equipped with
USB Type-C connectors.
on the convenience panel or the remote
Response
input=[Value]
Where [Value] is one of the following:
hdmi1
l
hdmi2
l
hdmi3
l
vga1
l
ops1
l
usbc1
l
android
l
none
l
74