Connecting Computers To The Display; Viewing A Connected Computer's Input - SMART Board SPNL-6365-V3 Manual

CHAPTER 2
USING THE DISPLAY

Connecting computers to the display

You can connect computers with SMART Learning Suite to the display (as shown below) and then
view the computers' input on the display.
NOTES
To interact with content, connect a USB cable to the appropriate USB Type-B receptacle on
l
the connector panel (as shown in the above diagram).
Your organization's installers might have connected cables to the display and run the cables
l
behind a wall or under the floor to a desk or table where you can place your computer.
If you have an older model iQ appliance (AM30), you can connect a computer to the
l
appliance and use the Input app to view the computer's input. For more information on the
Input app, see Using the iQ experience on page 21.

Viewing a connected computer's input

Use the Input app to view a connected computer's input on the display.
To view a connected computer's input
1. Connect the computer to the display.
2. Press the Input Select button
is selected.
27 smarttech.com/kb/171166
on the front control panel until HDMI1, HDMI2 or DisplayPort