Configuring Display Settings On Windows 2000; Determining Screen Assignments; Using The Dome Tab To Change Display Properties - Planar DOME Md5/DFP Installation Manual

Configuring Display Settings on Windows 2000
After you install the board and driver and set the default display
(see table below), you can change the resolution or any other
configuration option.
Use this tab...
DOME tab
Properties ->
Settings tab
The Windows 2000 operating system renumbers and reassigns
screens as you add them to the configuration. Set resolutions
or preferences only after all boards and screens are installed.
Restart your system to make sure the screen assignments
are stable.

Determining screen assignments

Click Identify in the Settings tab to match screens to boards.

Using the DOME tab to change display properties

You can change the display properties, such as resolution,
palette options, and brightness, using the DOME tab after
the display is attached to the Windows 2000 desktop.

Configuring Display Settings on Windows 2000 | 25

To set the default display for...
Displays attached to the
Windows 2000 desktop
Displays not attached to the
Windows 2000 desktop