Planar PU-16 Manual
  1. Manuals
  2. Brands
  3. Planar Manuals
  4. Controller
  5. PU-16
  6. Manual

Planar PU-16 Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
EN
Heater Controls /
Air Heaters /
PLANAR

Advertisement

Table of Contents
loading

Related Manuals for Planar PU-16

Summary of Contents for Planar PU-16

  • Page 1 Heater Controls / Air Heaters / PLANAR...

  • Page 2: Warranty

    Introduction This manual is part of documentation for PLANAR air heaters and provides information on safe maintenance of the product. If you have any problems, we strongly recommend that you contact authorized service centers, addresses and telephone numbers of which you can find out from the company, the seller or on the website www.autoterm.ru.
  • Page 3 Controller PU 1 - 4-digit LED indicator (indication of temperature, power or a fault code). 2 - LEDs (indication of operation mode) 3 - control buttons  selection of operation mode;  selection of sensor;  decreasing the desired setting of temperature or heat output.

  • Page 4: Status Indication

    Status Indication Operation of the heater in the Heat Control Mode Indication of Ventilation mode Operation of the heater in the Temperature Control Mode Cab sensor Sensor in the Controller Sensor in the heating unit Operation mode LED: – the heater is working; steady –...

  • Page 5: Operation Modes

    Operation Modes  designed to heat an interior space as quickly as possible;  has 8 steps of the operation mode ; «Heat Control»  the heater is constantly working at the set heat level..  designed to heat an interior space to a preset temperature; «Temperature ...
  • Page 6 After reaching the preset temperature: - If the Ventilation mode is not activated, the heater switches to "min." setting. Further operation of the heater depends on the ambient temperature in the room: 1) If the temperature continues to rise, the heater will continue to work at the "min" power level.

  • Page 7: Troubleshooting

    If the Temperature Control mode is selected (regardless of activation of the Ventilation mode), then the required value of temperature is set by pressing the buttons (decrease) or (increase) (in the range from 1 to 30ºС in the zone of the selected sensor).
  • Page 8 Table 1 Fault Description Comments. Solution Code Overheating of Check the intake and output of the heating unit for the heat unobstructed entry and exit of heated air. exchanger Check the intake and output of the heating unit for Overheating in unobstructed entry and exit of heated air.
  • Page 9 * - only for the air heaters PLANAR-8DM ** Attention! If, during the start-up and operation of the heater the error message "Overheating" is repeated 3 times in a row, the heater will be locked. Locking is made upon actual overheating, regardless of the input from the sensors that produced errors.

  • Page 10: Gsm Modem

    GSM Modem The operation of the heater can be controlled from a smart phone using a modem and a special application. A special connection is provided for the remote control of the heater by means of a GSM modem, designed for use in harsh environments (cold, vibration, etc.). Both the modem and the phone must have a SIM card installed.

Table of Contents