Configuring Display Settings; Determining Screen Assignments; Changing Display Properties - Planar Dome M2/PCI Installation Manual

Configuring Display Settings
After you install the board and driver and set the display
(see table below), you can change the resolution and refresh
rate or any other configuration option.
Use this tab...
DOME tab
Properties >
Settings tab
The Windows 2000 operating system renumbers and
reassigns screens as you add them to the configuration.
Set resolutions or preferences only after all boards and
screens are installed. Restart your system to make sure
the screen assignments are stable.

Determining screen assignments

Click Identify in the Settings tab to match screens to boards.

Changing display properties

You can change the display properties, such as resolution,
and palette options, using the DOME tab after the display
is attached to the Windows 2000 desktop.

Configuring Display Settings | 17

To set the default display for...
Displays attached to the
Windows 2000 desktop
Displays not attached to the
Windows 2000 desktop