Table of Contents
Advertisement
14 | Installing the Board and Driver in a PC
To install multiple boards
Remember these tips when installing multiple boards:
• The Windows 2000 driver supports as many Md5/DFP
boards as your system's power supply and available PCI
slots can support.
• For proper installation on both Windows 2000 and
Windows NT systems, you must install all the boards
first and then the drivers.
• The Windows NT driver (version 4.4.0 or later) supports
up to 8 Md5/DFP boards (16 screens).
• You cannot mix DOME board types; additional boards
must be Md5/DFP boards (Windows NT only).
• Each board requires less than 3 amps of +5V.
• You must disable VGA mode on all but one Md5/DFP
board if multiple boards are in use. See "Enabling or
disabling VGA mode" on page 9.
Advertisement
Table of Contents
