Table of Contents
Advertisement
42 | Installing the Board and Driver in a PC
Installing the Windows NT 4.0 Driver
This procedure assumes the Windows NT 4.0 operating system
is already installed on your system. If it is not, refer to the
Microsoft Windows NT 4.0 documentation.
Install the Md5/DFP board and connect it to the flat panel before
you install this driver. Failure to do so may cause problems with
the installation.
To install the driver
1.
Turn on the power to your computer, and select
Windows NT Workstation Version 4.00 [VGA].
2.
Log on with administrator privileges.
You need administrator privileges to change the
display settings.
3.
Right-click the desktop, and select Properties -> Settings.
The Settings tab appears.
4.
Click Display Type....
The Display Type dialog box appears.
5.
Click Change... in the Adapter Type section of the
dialog box.
The Change Display dialog box appears.
6.
Click Have Disk....
The Install From Disk dialog box appears, containing
this field:
Copy manufacturer's files from:
A:\
Advertisement
Table of Contents
