Enabling Or Disabling Vga Mode - Planar DOME Md5/DFP Installation Manual

Enabling or disabling VGA mode

This illustration details the location of DIP switches S1 and S2 on
the Md5/DFP board. Note the on/off position for the switches.
DIP switches on
the Md5/DFP
board
You must use DIP switch S1 to enable or disable VGA support.
This table shows the setting options for this switch.
DIP Switch S1
a. Indicates factory setting.
DIP switch S2 is reserved for software use. Default is all OFF.
On
1 VGA disabled
2 Flash enabled
3 FLASH page (0)
4 FLASH page (1)
Preparing for Board Installation | 9
Off
VGA enabled
a
Flash disabled
a
FLASH page (0)
a
FLASH page (1)
a