Table of Contents
Advertisement
24 | Installing the Board and Driver in a PC
To enable a display and set the display resolution
1.
Boot your computer in normal mode.
2.
Log on with administrator privileges.
3.
Right-click the desktop, and select Properties -> Settings.
4.
Click the Display list and select Default Monitor and
DOME Md5/DFP.
5.
Select Advanced -> Adapter -> List All Modes.
6.
Highlight the desired resolution, and click OK.
7.
Select Apply -> OK from the Default Monitor and
DOME Md5/DFP Properties dialog box.
8.
Select Extend my Windows desktop onto this monitor, and
click Apply.
This message appears:
Windows will now apply your new desktop settings.
The original desktop will be restored if the
settings are not applied correctly.
9.
Click OK to accept the new settings, or Cancel to revert to
the original settings.
If you have installed two or more CX displays, enable them as
described in steps 3–9.
Not all boards support two displays. Boards with part number
55-MD5FP2-xx drive two displays. To determine the part
number of your Md5/DFP board, check the sticker with the
CE mark on the video connector.
Advertisement
Table of Contents
