Planar DOME Md5/DFP Installation Manual page 33

To install the driver for an additional board
1. Turn off the power to your computer.
If you leave the computer turned on, you might suffer
electric shock or cause damage to both the computer
components and the Md5/DFP board.
2. Install the board, and follow the precautions and installation
steps on pages 8–13.
Make sure VGA is disabled on all Md5/DFP boards you
install subsequently.
3. Check that all flat-panel displays are connected and
powered on.
4. Turn on your computer and boot into VGA mode.
5. Log on with administrator privileges.
The Windows 2000 operating system recognizes the new
hardware device and prompts you to confirm the installation
of the DOME Md5/DFP board.
6. Click Yes.
7. Insert the WINFP CD, browse to find the
Win2k\MD5dfp\fp.5.0.x.yyy
(where x.yyy is a number that completes
the driver version, as in fp.5.0.1.009).
8. Continue the installation, then do either of the following:
• Install the second display on the board. (See page 22.)
Enable your display and set the resolution. (See page 24.)
• Restart your computer in normal mode if you have
installed a single-headed board. Enable your display and
set the resolution. (See page 24.)
Installing the Windows 2000 Driver | 21
directory