Supporting Vga With Another Board; Enabling Or Disabling Vga Mode - Planar DOME Md4/PCV Installation Manual

8 | Installing the Board and Driver

Supporting VGA with another board

To support VGA with another board, you must disable VGA
mode on the Md4/PCV board. (See page 10
When you install the Md4/PCV board in a computer that has an
existing VGA board, only one of the boards can support the
Windows NT operating system. You can run Windows NT on
either board, but you cannot run Windows NT on both boards
simultaneously.

Enabling or disabling VGA mode

Set the DIP switches, located near the top center of the Md4/PCV
board, to enable or disable VGA mode.
DIP switches on the Md4/PCV board
Disable VGA mode if you are using the Md4/PCV board
with an existing VGA board or with multiple Md4/PCV
boards. Enable VGA mode if you are using the VGA port
of the Md4/PCV board.
.)