Table of Contents
Advertisement
INSTALLATION
The Local Unit
Connect to the CPU
1.
Plug the cables of the Local Unit into the back of the CPU. (See Figure 1.)
a)
Connect the blue 15HD cable from the Local Unit to the female VGA port on the back of the CPU.
b)
Connect the USB Type A cable from the Local Unit to a female USB Type A port on the back of the CPU.
Note: If a SUN CPU is being connected, depending upon the video connector of the SUN CPU, it may be necessary to
attach an NTI #13W3M-15HDF (SUN video port-to-VGA adapter) to the video port on the CPU first, and then connect the
video cable to the adapter.
USB CPU
c)
If the Local Unit has Audio support (ST-C5USBVA-300 only), connect the black 3.5mm stereo plug into the "line
out", "speaker", or "headphones" jack on the back of the CPU. (See Figure 2)
Notes:
If all 3 jacks are available, use the jack marked "line out".
The "line out" jack is typically lime green and may be marked with this symbol
The "speaker" jack is typically orange, and may be marked with this symbol
The "headphones" jack may be marked with this symbol
d) If the Local Unit has 2-way audio support (ST-C5USBV2A-300), connect the 3 foot audio cable (supplied)
between the "MIC to CPU" jack and the microphone or "line in" port (pink) on the CPU.
USB Type A male
(BLUE- VIDEO)
15HD male
Video Connector
Figure 1- Connect the Local Unit to a CPU
Sun 13W3 Video Connector
(Rear View)
ST-C5USBV-300 Local Unit
6
NTI
R
Network Technologies Inc
XTENDEX
USB
Advertisement
Table of Contents
