Table of Contents
Advertisement
NTI XTENDEX 300 Foot DVI Video, Audio and IR Extender
LIMITATIONS
•
The use of CAT5e unshielded or all shielded CATx cabling will reduce the maximum distance and resolution.
PREPARATION FOR INSTALLATION
•
Locations should be chosen for the monitor that also has space to connect the Remote unit within the distance provided by
the cables.
If extension cables are needed, contact NTI for the cables required.
•
The CATx cables must be run to the locations where the Remote and Local units will be connected. Be careful to route the
cables away from any sources of magnetic fields or electrical interference that might reduce the quality of the video signal
(i.e. AC motors, welding equipment, fluorescent lighting, etc.).
•
All cables should be installed in such a way that they do not cause stress on their connections to the equipment. Extended
lengths of cable hanging from a connection may interfere with the quality of that connection.
minimize this.
•
Properly shut down and disconnect the power from the video source and monitor to be separated.
involved whose connections are being interrupted, be sure to refer to the instruction manuals for that equipment for proper
disconnection and reconnection procedures before proceeding.
WARNING: The CATx connection cable used between NTI XTENDEX Series Local and Remote or any XTENDEX Series
products must be wired straight through (pin 1 to pin 1, pin 2 to pin 2, etc.) The use of a CROSSOVER CABLE will
damage the extender and void your warranty.
4
Secure cables as needed to
If other equipment is
Advertisement
Table of Contents
