Table of Contents
Advertisement
Plug-in and Boot Up
1.
Plug the power cord(s) from the monitor(s) into power outlet(s).
2.
Connect the AC adapter power connectors to the 9VDC ports on the Remote and Local Units. (AC adapter shown in Figure
15)
3.
Plug the AC adapters into power outlets. The "Power" LED (Green) on the CAT5 connector of each unit should illuminate,
indicating that a proper power connection has been made.
4.
Turn ON the CPU and monitor(s). The CPU and monitor(s) should each react as if they were directly connected to each
other.
The yellow communication LEDs on the Remote and Local Units should blink indicating there is proper
communication between them.
Note: A loss of signal (blank screen) may be
experienced for an instant during the auto-
compensation process after powering-up (ST-
C5USBVA model only).
This may also occur if the
XTENDEX senses a loss of or weak signal connection
in the CAT5
cable.
USER
CPU
L
0
C
A
L
U
N
I
9V
NTI
R
1.5 A
T
1275 Danner Dr
Aurora, OH 44202
Tel:330- 562 - 7070
Fax:330- 56 2- 1999
www.networktechi nc.com
ST-C5U SBVA- 30 0M
Note: When using the microphone feature (ST-C5USV2A-300 model only), if both microphones are used at the same
time (one at the Local Unit and one at the Remote Unit), the audio data from both microphones will be "mixed" and sent
to the PC as one combined data stream.
ST-C5USBVA-300M
(Local Unit-Rearview)
Figure 15- Connect AC adapters
You will hear the combined audio from each through the speakers.
15
ST-C5USBV-300
Remote Unit
(Rear View)
Barrel
Power Connector
9VDC @ 1.0A OUTPUT
(Outside
barrel)
2.1 mm x 5.5 mm Female
9 VDC
Adapter
ADAPTER
(Inside
barrel)
Advertisement
Table of Contents
