Table of Contents
Advertisement
Note: It is recommended that the monitors connected to the Remote and Local units be of the same make and model.
Attention:
Some graphics cards will not send a video signal to the monitor until it has received the DDC information from the
monitor. In this case, the monitor may not display anything until the DDC information is read. This may occur if this is the first
time the monitor is being connected to the XTENDEX. The DDC information must be updated in the XTENDEX to achieve video
using the procedure outlined above.
If the monitor is changed to a different model than was initially installed, the update procedure must be repeated, either through
Command Mode or using the "DDC Update" button on the Local Unit.
COMMON APPLICATIONS
Figure 11 (below) illustrates three common applications for the ST-C5USBV-300 USB KVM Extender.
VGA
Multi-Scan
ST-C5USBV-300
Monitor
LOCAL UNIT
USB Mouse
USB Keyboard
Local User
ST-C5USBV-300
REMOTE UNIT
USB Mouse
STANDARD APPLICATION
BETWEEN USERS AND CPU
Figure 18- Examples of common applications for the ST-C5USBV-300 USB KVM Extender
Existing Local Unit Cable
VGA
Multi-Scan
Monitor
USB Mouse
USB Keyboard
Local User
CAT5 Cable
VGA
Multi-Scan
Monitor
USB Keyboard
Existing Local Unit Cable
ST-C5USBV-300
LOCAL UNIT
CAT5 Cable
ST-C5USBV-300
REMOTE UNIT
USB Mouse
USBVEXT-xx-MM
NTI USB
KVM MATRIX
SWITCH
(UNIMUX-nXm-U)
VGA
Multi-Scan
Monitor
USB Mouse USB Keyboard
BETWEEN CPU AND
MULTI-USER MATRIX
SWITCH
19
USBVEXT-xx-MM
NTI USB
KVM
SWITCH
(UNIMUX-xU)
Existing Local Unit Cable
VGA
Multi-Scan
ST-C5USBV-300
Monitor
LOCAL UNIT
USB Keyboard
Local User
CAT5 Cable
ST-C5USBV-300
REMOTE UNIT
Multi-Scan
Monitor
USB Mouse
USB Keyboard
BETWEEN SINGLE-
USER KVM SWITCH
AND USERS
VGA
Advertisement
Table of Contents
