Command Mode - NTI XTENDEX ST-C5USBVA-300M Installation And Operation Manual

COMMAND MODE

The XTENDEX has two areas of user control that can be used as needed.
below), or enable/disable MAC mode (see page 17)
To enter Command Mode, simultaneously press the left and right <Shift> keys on the keyboard connected to the Remote
Unit. The keyboard LEDs will illuminate.
To exit Command Mode, press <Esc>.
Automatic Video Quality Adjustment
Video quality adjustment is done automatically to assure the image is as clear as possible.
Note: If a different type of cable is used (i.e. shielded cable) and the image is not crisp and clear, there may be a need for
fine adjustment. For fine adjustment, follow the same procedure as described under "Manual Video Quality Adjustment"
below.
Manual Video Quality Adjustment
It is possible that on initial startup the image on the monitor will not be as crisp as the image normally is. This is due to the
frequency characteristics of the CAT5 cable.
the <Right Arrow> or <Left Arrow> keys on the remote keyboard until the image is crisp and clear.

Press <Right Arrow>key if the image is not crisp and clear enough.

Press the <Left Arrow> key if the image has been over-corrected (such that horizontal lines appear to trail or
shadow at the edge of an open window).

A momentary press of either key will make a minor change in the image.
Ultimately, the image quality should improve to a satisfactory level. Once the adjustment is made, it should not be necessary to
change it again, as the new settings are stored in memory and become the default settings with each startup. To exit Command
Mode, press <Esc>.
Note: For additional quality adjustment, it may be necessary to adjust the brightness and contrast settings of the
monitor.
Note: The video quality adjustment procedure can only be performed from the keyboard connected to the Remote Unit.
These controls are accessed by entering Command Mode.
(ST-C5USBVA/2A-300 only)
(ST-C5USBV-300 only)
It may be necessary to enter Command Mode (described above) and press
16
The user can adjust video quality (described