Table of Contents
Advertisement
NTI XTENDEX 300 Foot DVI Video, Audio and IR Extender
Connect the CATx Cables
Connect the CATx cable between the "CATx" ports on the Local and Remote Unit. (See Figure 3.) When properly inserted
the cable ends should snap into place.
WARNING: The CATx connection cable
used between NTI XTENDEX Series Local
and Remote or any XTENDEX Series
products must be wired straight through
(pin 1 to pin 1, pin 2 to pin 2, etc.) The
use of a CROSSOVER CABLE will
damage the extender and void your
warranty.
WARNING: Never connect the XTENDEX to an Ethernet card, Ethernet router, hub or switch or other Ethernet RJ45
!
connector of an Ethernet device. Damage to devices connected to the Ethernet may result.
Plug-in and Boot Up
1.
Plug the power cord from the monitor into the power outlet.
Connect an AC adapter power connector to the 24VDC port on the Remote Unit or the Local Unit. Plug the AC adapter into a
2.
power outlet. The green LED on the RJ45 connector of both the Remote and Local Units should illuminate, indicating that a
proper power connection has been made to them. (See Figure 3) The yellow LED on both the Local and Remote Units
should illuminate indicating there is communication between them.
3.
Turn ON the video/audio source and video display device. The source and display device should each react as if directly
connected to each other.
The AC adapter can be
connected to either the
Local Unit OR the
Remote Unit to make the
XTENDEX function
Figure 3- Connect CATx cable
Figure 4- Connect the AC adapter to the Remote Unit
6
Advertisement
Table of Contents
